SIP Client

Turn your phone system into a full functioning SIP/VOIP paging and intercom solution

SIP Client Application is the right firmware for your Barix device to integrate it into an existing VOIP phone system. SIP Client works with most SIP based VoIP solutions including Cisco Unified Communications Manager or Asterisk. Using the Session Initiation Protocol (SIP), the client device receives a phone number in addition to its IP address, and can communicate either on a peer-to-peer connection or over a proxy-based connection (PBX). Ringtone and busy tone guarantees that the call remains confidential and the recipient really receives the information. Featuring background music, audio rebroadcasting, priority audio port and special DTMF commands to quickly manage the device, the SIP Client expands the functionality to your SIP system. Even controlling the relays (e.g. to open door) of a Barix device via SIP phone is no problem with this solution. 

  • full-duplex phone communication
  • SIP (RFC 3261) compliant architecture
  • Supporting profiles for easy configuration
  • Configurable destination number to call for every input contact
  • Configurable call “pick up”/”hang off” timeout interval
  • Configurable “call/close on level” feature
  • Support for G.711 audio
  • Priority-based notification audio messaging
  • Configurable relay to switch on at call answer/call ring
  • Serial, UDP, TCP or CGI control interface
  • Transparent bidirectional Serial-To-TCP gateway
  • Friendly profile based WEB configuration UI
  • automatic network configuration (BOOTP, DHCP, IPzator)
  • DTMF door open key sequence
  • Barix X8 product support to add 8 additional inputs for predefined calls
  • Features priority notification port

Devices Available for SIP Client

SIP Client Annuncicom 60

Paging gateway, small zone device and Intercom device

  • MP3, Ogg Vorbis, G.711, G.722, PCM
  • Shoutcast/Icecast source capability
  • Mic/speaker connection
  • Amplified output 5W (8 Ohm)
  • Contact closure input
  • Power over Ethernet (PoE)

Ordering numbers for Annuncicom 60

  • 2012.9120
    Annuncicom 60
  • 2006.9072
    Wall mount bracket
  • 2007.9082 19’’
    Rack mount shelf (for up to 4 devices)

SIP Client Annuncicom 100

Intercom / Paging codec with contact closure inputs and relay output

  • MP3, G.711, G.722, PCM
  • Shoutcast/Icecast Source capability
  • Mic/speaker connection
  • Amplified Output 2W (8 Ohm)
  • Contact closure inputs, Relay output

Ordering numbers for Annuncicom 100

  • 2006.9062
    Annuncicom 100 EU package
  • 2006.9063
    Annuncicom 100 US package
  • 2006.9064
    Annuncicom 100 NoPSU package
  • 2006.9065
    Annuncicom 100 UK package
  • 2011.5032
    Accessories Power supply 24VDC
  • 2006.9072
    Accessories Wall mount bracket
  • 2007.9082
    Accessories 19“ Rack mount
  • 2006.9054
    Accessories Cable Set Audio

SIP Client Annuncicom 155

Industrial, ruggedized codec with rail certicfiation

  • MP3, G.711, PCM
  • Dual Ethernet
  • Supervised Speaker/Mic and IO
  • Wide operating range and shock proof
  • IP65 rated (EN50155)

Ordering numbers for Annuncicom 155

  • 2016.9186
    Annuncicom 155

    Device only. Power supply and mating connectors are offered separately as the accessory kit, below

  • 2010.9099 Annuncicom
    155 Accessory Kit contains
    – 24V power supply with M12 “A” connector
    – Sub-D 15 connector for Panel interface
    – M12 “A” connector for RS.485 interface
    – M12 “D” to RJ45 ethernet cable

SIP Client Annuncicom 200

Intercom / Paging codec with 8W amplifier

  • MP3, G.711, G.722, PCM
  • Shoutcast/Icecast Source capability
  • Mic/speaker and line level interfaces
  • Amplified output 8W (8 Ohm)
  • Contact closure inputs, relay output
  • Aiphone Door Station Interface (IE/JE series)

Ordering numbers for Annuncicom 200

  • 2008.9090
    Annuncicom 200 PoE package
  • 2011.5032
    Accessories Power supply 24VDC
  • 2006.9072
    Accessories Wall mount bracket
  • 2007.9082
    Accessories 19“ Rack mount
  • 2006.9054
    Accessories Cable Set Audio

SIP Client Annuncicom 1000

Advanced Intercom / Paging codec with supervised contact closures and relay outputs

  • MP3, G.711, G.722, PCM 
  • Balanced Audio interfaces
  • Contact closure input supervision
  • Redundant power and network
  • Switchable microphone input
  • Relay Output (8+1)
  • Battery Backup Supply Input

Ordering numbers for Annuncicom 1000

  • 2007.9076
    Annuncicom 1000 INTL

SIP Client Annuncicom PS1

IP Intercom and paging master station

  • Built-in speaker and microphone
  • Built in encoder and decoder
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Target/Function Buttons
  • Power over Ethernet (PoE)

Ordering numbers for Annuncicom PS1

  • 2012.9118
    Annuncicom PS1 INTL package

    Device only – Desktop stand with screws and rubber feet

  • 2012.9117
    Annuncicom PS1 Accessory Kit

    Package contents
    – Guiding bracket for gooseneck mic
    – Mini-jack gooseneck microphone

SIP Client Annuncicom PS Touch

Advanced IP Intercom and paging master station with security and redundancy

  • TCP/IP, RTP, UDP, ICMP, DHCP, SNMP
  • 5-Watt output speaker
  • AACplus, MP3, Ogg Vorbis, G.711, G.722, PCM Decoding
  • XLR microphone connector with 13 Volt bias voltage
  • Power over Ethernet (PoE)
  • 14 Softtouch Zone Selectors & 1 Hardware Paging Button

Ordering numbers for Annuncicom PS Touch

  • 2020.9305
    Annuncicom PS Touch SimplePaging
  • 2020.9315
    Annuncicom PS Touch IC-Paging

SIP Client Exstreamer 100, 105, 110, 120

IP Audio decoders for broadcast, interner radio and VoIP applications

  • AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Line Level Output (Stereo)
  • RS-232 Serial Port
  • Optional: Relay Output, IR receiver and Display
  • MicroSD or USB Flash Interface

Ordering numbers for Exstreamer 100, 105, 110, 120

  • 2005.9051
    Extreamer 100 EU package
  • 2005.9052
    Extreamer 100 US package
  • 2006.9056
    Extreamer 100 NoPSU package
  • 2006.9057
    Extreamer 100 UK package
  • 2011.9109
    Extreamer 105 EU package
  • 2011.9110
    Extreamer 105 US package
  • 2011.9111
    Extreamer 105 UK package
  • 2007.9079
    Extreamer 110 EU package
  • 2007.9080
    Extreamer 110 US package
  • 2007.9083
    Extreamer 110 UK package
  • 2008.9087
    Extreamer 110 NoPSU package
  • 2010.9100
    Extreamer 120 EU package
  • 2010.9101
    Extreamer 120 US package
  • 2010.9102
    Extreamer 120 UK package
  • 2010.9103
    Extreamer 120 NoSPU package
  • 2006.9072
    Wall Mounting Bracket
  • 2007.9082
    Barix 19″ Rack mount
  • 2006.9054
    Cable Set Audio
  • 2003.9017
    IR Kit (Reciever + Remote)

SIP Client Exstreamer 200, 205

IP Audio decoders that plays out via a built-in amplifier to 8 Ohm speakers

  • G.711, uLaw, aLaw, PCM Encoding
  • AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Amplified Output 2x25W (8 Ohm)
  • IR interface
  • MicroSD or USB Flash Interface

Ordering numbers for Exstreamer 200, 205

  • 2005.9055
    Exstreamer 200 EU/US package
  • 2011.9113
    Exstreamer 205 EU/US package
  • 2006.9054
    Cable Set Audio
  • 2003.9017
    IR Kit (Receiver + Remote)
  • 2006.9072
    Wall Mounting Bracket
  • 2007.9082
    Barix 19’’ Rack mount

SIP Client Exstreamer P5

PoE powered IP speaker to make any 8 Ohm speaker IP capable

  • AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Amplified Output 5W (8 Ohm)
  • RS-485 and IR port for local control
  • Powered over Ethernet (PoE)

Ordering numbers for Exstreamer P5

  • 2010.9104
    Exstreamer P5 PoE package

SIP Client IC Graph

Customized communication interfaces

  • Build user interfaces
  • Easy to configure
  • Java based
  • Free to use

Ordering numbers for IC Graph

Keep me updated about SIP Client

This is What Others have Achieved

Learn how Barix helped businesses like yours achieve greater success with custom-built solutions.

Show Similar Products