SIP Client

Turn your phone system into a full functioning SIP/VOIP paging and intercom solution.

SIP Client Application is the right firmware for your Barix device to integrate it into an existing VOIP phone system. SIP Client works with most SIP based VoIP solutions including Cisco Unified Communications Manager or Asterisk. Using the Session Initiation Protocol (SIP), the client device receives a phone number in addition to its IP address, and can communicate either on a peer-to-peer connection or over a proxy-based connection (PBX). Ringtone and busy tone guarantees that the call remains confidential and the recipient really receives the information. Featuring background music, audio rebroadcasting, priority audio port and special DTMF commands to quickly manage the device, the SIP Client expands the functionality to your SIP system. Even controlling the relays (e.g. to open door) of a Barix device via SIP phone is no problem with this solution.

  • full-duplex phone communication
  • SIP (RFC 3261) compliant architecture
  • Supporting profiles for easy configuration
  • Configurable destination number to call for every input contact
  • Configurable call “pick up”/”hang off” timeout interval
  • Configurable “call/close on level” feature
  • Support for G.711 audio
  • Priority-based notification audio messaging
  • Configurable relay to switch on at call answer/call ring
  • Serial, UDP, TCP or CGI control interface
  • Transparent bidirectional Serial-To-TCP gateway
  • Friendly profile based WEB configuration UI
  • automatic network configuration (BOOTP, DHCP, IPzator)
  • DTMF door open key sequence
  • Barix X8 product support to add 8 additional inputs for predefined calls
  • Features priority notification port

Devices Available for SIP Client

SIP Client Annuncicom 60

Paging gateway, small zone device and Intercom device

  • MP3, Ogg Vorbis, G.711, G.722, PCM
  • Shoutcast/Icecast source capability
  • Mic/speaker connection
  • Amplified output 5W (8 Ohm)
  • Contact closure input
  • Power over Ethernet (PoE)

Ordering numbers for Annuncicom 60

2012.9120 Annuncicom 60

2006.9072 Wall mount bracket

2007.9082 19’’ Rack mount shelf (for up to 4 devices)

SIP Client Annuncicom 100

Intercom / Paging codec with contact closure inputs and relay output

  • MP3, G.711, G.722, PCM
  • Shoutcast/Icecast Source capability
  • Mic/speaker connection
  • Amplified Output 2W (8 Ohm)
  • Contact closure inputs, Relay output

Ordering numbers for Annuncicom 100

2006.9062 Annuncicom 100 EU package

2006.9063 Annuncicom 100 US package

2006.9064 Annuncicom 100 NoPSU package

2006.9065P Annuncicom 100 UK package

2011.5032 Accessories Power supply 24VDC

2006.9072 Accessories Wall mount bracket

2007.9082 Accessories 19“ Rack mount

2006.9054 Accessories Cable Set Audio

SIP Client Annuncicom 155

Industrial, ruggedized codec with rail certicfiation

  • MP3, G.711, PCM
  • Dual Ethernet
  • Supervised Speaker/Mic and IO
  • Wide operating range and shock proof
  • IP65 rated (EN50155)

Ordering numbers for Annuncicom 155

2016.9186 Annuncicom 155Device only. Power supply and mating connectors are offered separately as the accessory kit, below

2010.9099 Annuncicom 155 Accessory Kit contains
– 24V power supply with M12 “A” connector
– Sub-D 15 connector for Panel interface
– M12 “A” connector for RS.485 interface
– M12 “D” to RJ45 ethernet cable

SIP Client Annuncicom 200

Intercom / Paging codec with 8W amplifier

  • MP3, G.711, G.722, PCM
  • Shoutcast/Icecast Source capability
  • Mic/speaker and line level interfaces
  • Amplified output 8W (8 Ohm)
  • Contact closure inputs, relay output
  • Aiphone Door Station Interface (IE/JE series)

Ordering numbers for Annuncicom 200

2008.9090 Annuncicom 200 PoE package

2011.5032 Accessories Power supply 24VDC

2006.9072 Accessories Wall mount bracket

2007.9082 Accessories 19“ Rack mount

2006.9054 Accessories Cable Set Audio

SIP Client Annuncicom 1000

Advanced Intercom / Paging codec with supervised contact closures and relay outputs

  • MP3, G.711, G.722, PCM
  • Balanced Audio interfaces
  • Contact closure input supervision
  • Redundant power and network
  • Switchable microphone input
  • Relay Output (8+1)
  • Battery Backup Supply Input

Ordering numbers for Annuncicom 1000

2007.9076 Annuncicom 1000 INTL

SIP Client Annuncicom PS1

IP Intercom and paging master station

  • Built-in speaker and microphone
  • Built in encoder and decoder
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Target/Function Buttons
  • Power over Ethernet (PoE)

Ordering numbers for Annuncicom PS1

2012.9118 Annuncicom PS1 INTL packageDevice only – Desktop stand with screws and rubber feet

2012.9117 Annuncicom PS1 Accessory KitPackage contents
– Guiding bracket for gooseneck mic
– Mini-jack gooseneck microphone

SIP Client Annuncicom PS Touch

Advanced IP Intercom and paging master station with security and redundancy

  • TCP/IP, RTP, UDP, ICMP, DHCP, SNMP
  • 5-Watt output speaker
  • AACplus, MP3, Ogg Vorbis, G.711, G.722, PCM Decoding
  • XLR microphone connector with 13 Volt bias voltage
  • Power over Ethernet (PoE)
  • 14 Softtouch Zone Selectors & 1 Hardware Paging Button

Ordering numbers for Annuncicom PS Touch

2020.9305P Annuncicom PS Touch Simple Paging

2022.9361P Annuncicom PS Touch 400 Package

2021.9353p Annuncicom PS Touch 400 OEM

SIP Client Exstreamer 100, 110, 120 (Exstreamer 105 OBSOLETE)

IP Audio decoders for broadcast, interner radio and VoIP applications

  • AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Line Level Output (Stereo)
  • RS-232 Serial Port
  • Optional: Relay Output, IR receiver and Display
  • MicroSD or USB Flash Interface

Ordering numbers for Exstreamer 100, 110, 120 (Exstreamer 105 OBSOLETE)

Exstreamer 100 (Made in China)

2005.9051 Extreamer 100 EU Package

2005.9052 Extreamer 100 US Package

2006.9056 Extreamer 100 NoPSU Package

2006.9057 Extreamer 100 UK Package

Exstreamer 105 (Made in China) OBSOLETE

2011.9109P Extreamer 105 EU Package OBSOLETE

2011.9110P Extreamer 105 US Package OBSOLETE

2011.9111P Exstreamer 105 NoPSU Package OBSOLETE

Exstreamer 105 (Made in China) OBSOLETE

2011.9112P Extreamer 105 UK Package OBSOLETE

Exstreamer 110 (Made in China)

2007.9079 Extreamer 110 EU Package

2007.9080 Extreamer 110 US Package

2007.9083 Extreamer 110 UK Package

2008.9087 Extreamer 110 NoPSU Package

Exstreamer 120 (Made in China)

2010.9100P Extreamer 120 EU Package

2010.9101 Extreamer 120 US Package

2010.9102 Extreamer 120 UK Package

2010.9103 Extreamer 120 NoSPU Package

 

2006.9072 Wall Mounting Bracket

2007.9082 Barix 19″ Rack mount

2006.9054 Cable Set Audio

2003.9017 IR Kit (Reciever + Remote)

SIP Client Exstreamer 200, 205

IP Audio decoders that plays out via a built-in amplifier to 8 Ohm speakers

  • G.711, uLaw, aLaw, PCM Encoding
  • AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Amplified Output 2x25W (8 Ohm)
  • IR interface
  • MicroSD or USB Flash Interface

Ordering numbers for Exstreamer 200, 205

2006.9055 Exstreamer 200 EU/US package

2011.9113P Exstreamer 205 EU/US package

2006.9054 Cable Set Audio

2003.9017 IR Kit (Receiver + Remote)

2006.9072 Wall Mounting Bracket

2007.9082 Barix 19’’ Rack mount

SIP Client Exstreamer P5

PoE powered IP speaker to make any 8 Ohm speaker IP capable

  • AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
  • IP Streaming via TCP, UDP, RTP, Multicast
  • Amplified Output 5W (8 Ohm)
  • RS-485 and IR port for local control
  • Powered over Ethernet (PoE)

Ordering numbers for Exstreamer P5

2010.9104 Exstreamer P5 PoE package

SIP Client ICGraph

Customized communication interfaces

  • Build user interfaces
  • Easy to configure
  • Java based
  • Free to use

Ordering numbers for ICGraph

Keep me updated about SIP Client