SIP Client - Barix

SIP Client

Turn your phone system into a full functioning SIP/VOIP paging and intercom solution.

SIP Client Application is the right firmware for your Barix device to integrate it into an existing VOIP phone system. SIP Client works with most SIP based VoIP solutions including Cisco Unified Communications Manager or Asterisk. Using the Session Initiation Protocol (SIP), the client device receives a phone number in addition to its IP address, and can communicate either on a peer-to-peer connection or over a proxy-based connection (PBX). Ringtone and busy tone guarantees that the call remains confidential and the recipient really receives the information. Featuring background music, audio rebroadcasting, priority audio port and special DTMF commands to quickly manage the device, the SIP Client expands the functionality to your SIP system. Even controlling the relays (e.g. to open door) of a Barix device via SIP phone is no problem with this solution.

Show all Feature Details

full-duplex phone communication
SIP (RFC 3261) compliant architecture
Supporting profiles for easy configuration
Configurable destination number to call for every input contact
Configurable call “pick up”/”hang off” timeout interval
Configurable “call/close on level” feature
Support for G.711 audio
Priority-based notification audio messaging
Configurable relay to switch on at call answer/call ring
Serial, UDP, TCP or CGI control interface
Transparent bidirectional Serial-To-TCP gateway
Friendly profile based WEB configuration UI
automatic network configuration (BOOTP, DHCP, IPzator)
DTMF door open key sequence
Barix X8 product support to add 8 additional inputs for predefined calls
Features priority notification port

Devices Available for SIP Client

SIP Client Annuncicom 60

Paging gateway, small zone device and Intercom device

MP3, Ogg Vorbis, G.711, G.722, PCM
Shoutcast/Icecast source capability
Mic/speaker connection
Amplified output 5W (8 Ohm)
Contact closure input
Power over Ethernet (PoE)

Detailed product sheet

Ordering numbers for Annuncicom 60

2012.9120
Annuncicom 60
2006.9072
Wall mount bracket
2007.9082 19’’
Rack mount shelf (for up to 4 devices)

SIP Client Annuncicom 100

Intercom / Paging codec with contact closure inputs and relay output

MP3, G.711, G.722, PCM
Shoutcast/Icecast Source capability
Mic/speaker connection
Amplified Output 2W (8 Ohm)
Contact closure inputs, Relay output

Detailed product sheet

Ordering numbers for Annuncicom 100

2006.9062
Annuncicom 100 EU package
2006.9063
Annuncicom 100 US package
2006.9064
Annuncicom 100 NoPSU package
2006.9065
Annuncicom 100 UK package
2011.5032
Accessories Power supply 24VDC
2006.9072
Accessories Wall mount bracket
2007.9082
Accessories 19“ Rack mount
2006.9054
Accessories Cable Set Audio

SIP Client Annuncicom 155

Industrial, ruggedized codec with rail certicfiation

MP3, G.711, PCM
Dual Ethernet
Supervised Speaker/Mic and IO
Wide operating range and shock proof
IP65 rated (EN50155)

Detailed product sheet

Ordering numbers for Annuncicom 155

2016.9186
Annuncicom 155Device only. Power supply and mating connectors are offered separately as the accessory kit, below
2010.9099 Annuncicom
155 Accessory Kit contains
– 24V power supply with M12 “A” connector
– Sub-D 15 connector for Panel interface
– M12 “A” connector for RS.485 interface
– M12 “D” to RJ45 ethernet cable

SIP Client Annuncicom 200

Intercom / Paging codec with 8W amplifier

MP3, G.711, G.722, PCM
Shoutcast/Icecast Source capability
Mic/speaker and line level interfaces
Amplified output 8W (8 Ohm)
Contact closure inputs, relay output
Aiphone Door Station Interface (IE/JE series)

Detailed product sheet

Ordering numbers for Annuncicom 200

2008.9090
Annuncicom 200 PoE package
2011.5032
Accessories Power supply 24VDC
2006.9072
Accessories Wall mount bracket
2007.9082
Accessories 19“ Rack mount
2006.9054
Accessories Cable Set Audio

SIP Client Annuncicom 1000

Advanced Intercom / Paging codec with supervised contact closures and relay outputs

MP3, G.711, G.722, PCM
Balanced Audio interfaces
Contact closure input supervision
Redundant power and network
Switchable microphone input
Relay Output (8+1)
Battery Backup Supply Input

Detailed product sheet

Ordering numbers for Annuncicom 1000

2007.9076
Annuncicom 1000 INTL

SIP Client Annuncicom PS1

IP Intercom and paging master station

Built-in speaker and microphone
Built in encoder and decoder
IP Streaming via TCP, UDP, RTP, Multicast
Target/Function Buttons
Power over Ethernet (PoE)

Detailed product sheet

Ordering numbers for Annuncicom PS1

2012.9118
Annuncicom PS1 INTL packageDevice only – Desktop stand with screws and rubber feet
2012.9117
Annuncicom PS1 Accessory KitPackage contents
– Guiding bracket for gooseneck mic
– Mini-jack gooseneck microphone

SIP Client Annuncicom PS Touch

Advanced IP Intercom and paging master station with security and redundancy

TCP/IP, RTP, UDP, ICMP, DHCP, SNMP
5-Watt output speaker
AACplus, MP3, Ogg Vorbis, G.711, G.722, PCM Decoding
XLR microphone connector with 13 Volt bias voltage
Power over Ethernet (PoE)
14 Softtouch Zone Selectors & 1 Hardware Paging Button

Detailed product sheet

Ordering numbers for Annuncicom PS Touch

2020.9305P
Annuncicom PS Touch Simple Paging
2022.9361P
Annuncicom PS Touch 400 Package
2021.9353p Annuncicom PS Touch 400 OEM

SIP Client Exstreamer 100, 110, 120 (Exstreamer 105 OBSOLETE)

IP Audio decoders for broadcast, interner radio and VoIP applications

AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
IP Streaming via TCP, UDP, RTP, Multicast
Line Level Output (Stereo)
RS-232 Serial Port
Optional: Relay Output, IR receiver and Display
MicroSD or USB Flash Interface

Detailed product sheet

Ordering numbers for Exstreamer 100, 110, 120 (Exstreamer 105 OBSOLETE)

2005.9051
Extreamer 100 EU package
2005.9052
Extreamer 100 US package
2006.9056
Extreamer 100 NoPSU package
2006.9057
Extreamer 100 UK package
2011.9109
Extreamer 105 EU package (OBSOLETE)
2011.9110
Extreamer 105 US package (OBSOLETE)
2011.9111
Extreamer 105 UK package (OBSOLETE)
2007.9079
Extreamer 110 EU package
2007.9080
Extreamer 110 US package
2007.9083
Extreamer 110 UK package
2008.9087
Extreamer 110 NoPSU package
2010.9100
Extreamer 120 EU package
2010.9101
Extreamer 120 US package
2010.9102
Extreamer 120 UK package
2010.9103
Extreamer 120 NoSPU package
2006.9072
Wall Mounting Bracket
2007.9082
Barix 19″ Rack mount
2006.9054
Cable Set Audio
2003.9017
IR Kit (Reciever + Remote)

SIP Client Exstreamer 200, 205

IP Audio decoders that plays out via a built-in amplifier to 8 Ohm speakers

G.711, uLaw, aLaw, PCM Encoding
AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
IP Streaming via TCP, UDP, RTP, Multicast
Amplified Output 2x25W (8 Ohm)
IR interface
MicroSD or USB Flash Interface

Detailed product sheet

Ordering numbers for Exstreamer 200, 205

2005.9055
Exstreamer 200 EU/US package
2011.9113
Exstreamer 205 EU/US package
2006.9054
Cable Set Audio
2003.9017
IR Kit (Receiver + Remote)
2006.9072
Wall Mounting Bracket
2007.9082
Barix 19’’ Rack mount

SIP Client Exstreamer P5

PoE powered IP speaker to make any 8 Ohm speaker IP capable

AACplus, MP3, Ogg Vorbis, G.711, PCM Decoding
IP Streaming via TCP, UDP, RTP, Multicast
Amplified Output 5W (8 Ohm)
RS-485 and IR port for local control
Powered over Ethernet (PoE)

Detailed product sheet

Ordering numbers for Exstreamer P5

2010.9104
Exstreamer P5 PoE package

SIP Client ICGraph

Customized communication interfaces

Build user interfaces
Easy to configure
Java based
Free to use

Ordering numbers for ICGraph

Keep me updated about SIP Client